This model is designed for riders aged 8 to 12 years, with a 24‑inch wheel diameter that matches the ISO 507 standard. The frame geometry provides a low stand‑over height of 620 mm and a reach of 380 mm, allowing confident handling on loose terrain.
The main triangle uses 6061‑T6 aluminum alloy with a wall thickness of 1.2 mm on the down tube and 0.9 mm on the seat stays, resulting in a frame weight of approximately 1.8 kg. Tube shaping incorporates hydroformed sections to increase torsional stiffness by roughly 15 % compared with round tubing of the same weight.
A 80 mm travel air‑sprung fork is mounted, featuring 30 mm stanchions and a rebound adjuster accessible via a knob on the crown. The fork’s air spring allows pressure settings from 40 psi to 80 psi to accommodate rider weights between 25 kg and 45 kg.
Shifting is handled by a Shimano Altus 21‑speed drivetrain, offering a gear range of 0.84 to 3.92 (gain ratio) with a 14‑28 T cassette and a triple crankset (22‑32‑42 T). Braking relies on Tektro hydraulic disc brakes with 160 mm rotors front and rear, delivering a consistent lever pull force of under 20 N at 150 N cable tension.
Rims are double‑wall alloy, 24 mm internal width, with a spoke count of 28 per wheel and a tension target of 110 kgf. Tires are 24×2.10 in, featuring a knob‑pattern tread optimized for loose soil, inflated to 20–35 psi depending on terrain.
The frame is tested to a static load of 150 kg using a three‑point bending fixture, which corresponds to a safety factor of approximately 3.3 for the maximum rider weight of 45 kg plus gear. Fatigue testing follows ISO 4210‑2 standards, completing 100 000 load cycles at 80 % of the ultimate load without visible damage.
| Parameter | Typical Value |
|---|---|
| Wheel size | 24 in (ISO 507) |
| Frame material | 6061‑T6 aluminum alloy |
| Frame weight | ≈1.8 kg |
| Fork travel | 80 mm air‑sprung |
| Drivetrain | Shimano Altus 21‑speed (3×7) |
| Brake type | Hydraulic disc, 160 mm rotor |
| Tire size | 24×2.10 in, knob tread |
| Maximum rider weight | 45 kg |
| Weight limit (static test) | 150 kg |
| Typical production lead time | 4‑6 weeks after sample approval |
Each frame undergoes visual inspection for weld uniformity, followed by dimensional verification using a CMM with a tolerance of ±0.2 mm on critical mounting points. Before packaging, a functional test is performed: shifting through all gears under load, brake lever actuation measured with a load cell, and fork compression checked at 50 % travel.
The low bottom bracket height (280 mm) and short chainstay (380 mm) improve maneuverability on singletrack, while the 24‑inch wheel size maintains sufficient roll‑over capability for roots and rocks. These characteristics make the bike suitable for youth mountain‑bike clubs, school outdoor programs, and entry‑level trail centers where rider confidence and safety are priorities.
Minimum order quantity is 50 units, with sample units available upon request for a fee that is credited toward the first production run. Production lead time averages 4‑6 weeks after final approval of drawings and material specifications, assuming standard component availability.
© SKYS Bicycle Technology Co., Ltd. All Right Reserved. Sitemap | Privacy Policy